SAAB WIS ONLINE

ME9 / P0101 00

Read the instructions below then start the fault diagnostic procedure.

  P0101 00


Mass Air Flowsensor, Performace Problem (Deviation from Calculated Mass Air)



On-board diagnosis

Type of diagnosis:

Continuous

Enable criteria:

Battery voltage must be between 10 - 18 V.
Engine running.
NONE of the following DTCs must be detected:
P0102, P0103
P2176

Fault criteria:


Incorrect air mass in relation to throttle position for more than 2 seconds.

OK report:

Fault criteria NOT fulfilled.

Fault handling:

Type III
(See section Fault handling III, "Other emission-related components and functions" for more information.)

Checking the wiring harness

Move the wiring harness at several spots and in several directions to reveal intermittent breaks and short-circuits. Check switches, connectors and crimp connections for oxidation, retracted pins and pin clamping force.

Diagnostic help

Diagnosis regards:

The DTC indicates that the value from the mass air flow sensor has been deemed unreliable after comparison with a calculated value. This could be due to an air leak or a faulty mass air flow sensor.
IMPORTANT
A crankcase ventilation leak may be one reason as to why a DTC is set. Check crankcase ventilation function before starting regular troubleshooting.

Functions in the diagnostic tool related to the fault:

Test value:
Mass Air Flow Sensor
Air Mass Flow
Requested Throttle Position

(See section Fault handling III, "Other emission-related components and functions" for more information.)