SAAB WIS ONLINE

ME9 / P0130 00

Symptom: Malfunction Indicator Lamp

  P0130 00


O2S 1 Evaluation Fault/Sensor in Air

Fault symptom

Malfunction Indicator Lamp

On-board diagnosis

Type of diagnosis:

Continuous

Enable criteria:

Test 1
Engine running.
Sensor in normal operating range (715°C and up).
Desired lambda value is less than 1.6.
Voltage across the Nernst cell is 3.7 - 4.8 V.
NONE of the following DTCs must be detected:
P0607

Test 2
Engine running.
Closed loop lambda control active.

Fault criteria:


Test 1
The control module detects that no hydrocarbons are passing the sensor because it is not mounted in the exhaust pipe.

Test 2
The control module detects a fault on the sensor circuit, but not precisely which fault.
Run additional operating cycles until another O2S 1 DTC is detected. Then follow fault diagnosis for that DTC.

Checking the wiring harness


Move the wiring harness at several spots and in several directions to reveal intermittent breaks and short-circuits. Check switches, connectors and crimp connections for oxidation, retracted pins and pin clamping force.

Diagnostic help

Functions in the diagnostic tool related to the fault:

Test value:
Requested O2S1 Lambda
O2S1 lambda
O2S1 Pump Current
O2S 1 Preheating

(See also description of readings/activations in diagnostic tool)