SAAB WIS ONLINE

ME9 / P0135 00

Read the instructions below then start the fault diagnostic procedure.

Symptom: Malfunction Indicator Lamp

  P0135 00


O2S 1 Heater Resistance, Out of Range

Fault symptom

Malfunction Indicator Lamp

On-board diagnosis

Type of diagnosis:

Continuous

Enable criteria:

General conditions for this DTC
Battery voltage should be between 10.7 and 18 Volts.
Test 1
Engine running.
Preheating active.

Test 2
Engine has been switched off for at least 1½ h before this start.
Coolant temperature over -10°C.

Fault criteria:


Test 1
PWM signal has been requested 100% for 60 seconds even though 715°C not reached.

Test 2
Preheating does not reach 715°C within 35 seconds of cold start.

Checking the wiring harness


Move the wiring harness at several spots and in several directions to reveal intermittent breaks and short-circuits. Check switches, connectors and crimp connections for oxidation, retracted pins and pin clamping force.

Diagnostic help

Diagnosis regards:

Electrical fault in connecting leads or component.

Functions in the diagnostic tool related to the fault:

Test value:
O2S 1 Preheating

Activation:
O2S 1 Preheating

(See also description of readings/activations in diagnostic tool)