SAAB WIS ONLINE

T8 / P0103 00

Read the instructions below then start the fault diagnostic procedure.

Symptom: Fault indicator lamp (for further information see WIS Fault diagnosis, general) Cruise control not working. Limp home

  P0103 00


Mass Air Flow Circuit. High Input.

Fault symptom

Fault indicator lamp (for further information see WIS Fault diagnosis, general)

Cruise control not working.

Limp home

On-board diagnosis

Type of diagnosis:

Continuous

Enable criteria:

Battery voltage must be between 11 - 16 V.
Ignition ON.

Fault criteria:

When the frequency is higher than 11500 Hz on the input.
(High frequency results in low flow)

Dependent:

None

System reaction to a fault:

The system continues to function with a calculated air mass instead of the value from the mass air flow sensor.
Boost pressure adaption is blocked and reset.
Limited acceleration and idle function.
Cruise control blocked.
Secondary air switched off.

OK report:

Fault criteria NOT fulfilled for 2 s.

Fault handling:

Type III
(See section Fault handling III, "Other emission-related components and functions" for more information.)

Checking the wiring harness

Move the wiring harness at several spots and in several directions to reveal intermittent breaks and short-circuits. Check switches, connectors and crimp connections for oxidation, retracted pins and pin clamping force.

Diagnostic help

Diagnosis regards:

Electrical fault in connecting leads or component.

Functions in the diagnostic tool related to the fault:

Test value:
Air Mass

(See also description of readings/activations in diagnostic tool)