SAAB WIS ONLINE

T8 / P0131 00

Read the instructions below then start the fault diagnostic procedure.

Symptom: Fault indicator lamp (for further information see WIS Fault diagnosis, general)

  P0131 00


O2S Circuit. Low Voltage. Sensor 1.

Fault symptom

Fault indicator lamp (for further information see WIS Fault diagnosis, general)

On-board diagnosis

Type of diagnosis:

Continuous

Enable criteria:

Battery voltage must be between 11 - 16 V.
Engine running.
No fuel shut-off.
Secondary air pump not active, if fitted.
EVAP, leak diagnosis not active, if OBDII.
Preheating active for more than 4 s.
Lambda control active for more then 5 s.
NONE of the following DTCs must be detected:
P0101, P0102, P0103

Fault criteria:

When voltage across oxygen sensor 1 is less than 100 mV while voltage across oxygen sensor 2 is more than 700 mV for more than 30 s.

Dependent:

None

System reaction to a fault:

Closed loop is blocked.
Preheating of oxygen sensors 1 and 2 is stopped.
Fuel adaptation is reset and switched off.

OK report:

Fault criteria NOT fulfilled for 31 s.

Fault handling:

Type III
(See section Fault handling III, "Other emission-related components and functions" for more information.)

Checking the wiring harness

Move the wiring harness at several spots and in several directions to reveal intermittent breaks and short-circuits. Check switches, connectors and crimp connections for oxidation, retracted pins and pin clamping force.

Diagnostic help

Diagnosis regards:

Electrical fault in connecting leads or component.

Functions in the diagnostic tool related to the fault:

Test value:
O2S 1
Closed Loop

(See also description of readings/activations in diagnostic tool)