T8 / P1340 00
Read the instructions below then
start the fault diagnostic procedure.
Symptom: Fault indicator lamp (for further information see WIS Fault diagnosis, general)
Combustion Detection Signals CDM-T8, Open/Short
Fault symptom
Fault indicator lamp (for further information see WIS Fault diagnosis, general)
On-board diagnosis
Type of diagnosis:
Enable criteria:
Fault criteria:
No combustion signal detected from several cylinders. It was nevertheless possible to synchronize the camshaft position with the crankshaft position. |
Dependent:
System reaction to a fault:
OK report:
When ignition and fuel injection are synchronised. |
Fault handling:
(See section Fault handling III, "Other emission-related components and functions" for more information.) |
Checking the wiring harness
Move the wiring harness at several spots and in several directions to reveal intermittent breaks and short-circuits. Check switches, connectors and crimp connections for oxidation, retracted pins and pin clamping force.
Diagnostic help
Diagnosis regards:
Electrical fault in the connecting leads or in the CDM. |
Functions in the diagnostic tool related to the fault:
• | Combustion Signal cyl 1+3 |
• | Combustion Signal cyl 2+4 |
• | Camshaft Position Syncronized |
(See also description of readings/activations in diagnostic tool) |