SAAB WIS ONLINE

T8 / P1623 00

Read the instructions below then start the fault diagnostic procedure.

Symptom: Fault indicator lamp (for further information see WIS Fault diagnosis, general) Message appears in display. Limp home

  P1623 00


TCM Missing on BUS

Fault symptom

Fault indicator lamp (for further information see WIS Fault diagnosis, general)

Message appears in display.

Limp home

On-board diagnosis

Type of diagnosis:

Continuous

Enable criteria:

Ignition on for at least 3 s.
Battery voltage must be between 6 - 18 V.

Fault criteria:

No communication with TCM for 1.25 s.

Dependent:

P0600

System reaction to a fault:

Torque limited to max. 170Nm.

OK report:

Fault criteria NOT fulfilled for 2 s.

Fault handling:

Type III
CHECK ENGINE off and any DTC are immediately cleared as soon as TCM no longer requests CHECK ENGINE.
(See section Fault handling III, "Other emission-related components and functions" for more information.)

Checking the wiring harness

Move the wiring harness at several spots and in several directions to reveal intermittent breaks and short-circuits. Check switches, connectors and crimp connections for oxidation, retracted pins and pin clamping force.

Diagnostic help

Diagnosis regards:

Electrical fault on bus leads or in the component.
Fault diagnosis for automatic transmission (TCM) should be carried out.

Functions in the diagnostic tool related to the fault:

Response test, under "All/Bus" menu.
Read / Reset Bus Configuration
Read / Clear Bus Off Counter