T8 / P1681 00
Read the instructions below then
start the fault diagnostic procedure.
Symptom: Fault indicator lamp (for further information see WIS Fault diagnosis, general)
Limp home
Control Module. Internal Fault
Fault symptom
Fault indicator lamp (for further information see WIS Fault diagnosis, general)
Limp home
On-board diagnosis
Type of diagnosis:
Enable criteria:
When the ECM is awake, diagnosis is active (even with the ignition off). |
Fault criteria:
No pulses generated to the control module input of throttle position sensor 2. |
Dependent:
System reaction to a fault:
OK report:
Fault criterion not fulfilled and vehicle speed over 0 km/h for more than 60 s. |
Fault handling:
(See section Fault handling III, "Other emission-related components and functions" for more information.) |
Diagnostic help
Diagnosis regards:
To locate electrical faults in the control module internal electronics. |
See "Before changing a control module" and "After fitting a control module" under Fault diagnosis, general. |
Functions in the diagnostic tool related to the fault:
See menu "All - Add/Remove" |