TCM EDC16 / P0720 08
Read the instructions below then
start the fault diagnostic procedure.
Symptom: Message appears in display.
Output RPM Sensor Circuit, Faulty Signal
Fault symptom
Message appears in display.
On-board diagnosis
Type of diagnosis:
Enable criteria:
Engine running and not in limp home mode. |
Fault criteria:
Control module receives no voltage from the output speed sensor. |
Control module receives no value from output speed sensor but receives value from the input speed sensor. |
System reaction to a fault:
If the DTC remains during several test cycles: |
Checking the wiring harness
Move the wiring harness at several spots and in several directions to reveal intermittent breaks and short-circuits. Check switches, connectors and crimp connections for oxidation, retracted pins and pin clamping force.
Diagnostic help
Diagnosis regards:
Electrical fault in connecting leads or component. |