SAAB WIS ONLINE

TCM T8 / P0828 01

Read the instructions below then start the fault diagnostic procedure.

Symptom: No Sentronic function. Selector lever locked in position P or N.

  P0828 01


Sentronic Circuit, Short to B+

Fault symptom

No Sentronic function.

Selector lever locked in position P or N.

On-board diagnosis

Type of diagnosis:

Continuous

Enable criteria:

Engine running and not in limp home mode.
System voltage should be 9 - 16 V.

Fault criteria:

Input voltage exceeds 6.7 +/- 0.8 V for more than 30 s.

System reaction to a fault:

Manual shifting not permitted.

Checking the wiring harness

Move the wiring harness at several spots and in several directions to reveal intermittent breaks and short-circuits. Check switches, connectors and crimp connections for oxidation, retracted pins and pin clamping force.

Diagnostic help

Diagnosis regards:

Electrical fault in lead connected between SLM and TCM.
____________________________________
IMPORTANT
If this DTC is stored, DTC P1802 02 or P1802 05 should also be stored in SLM. Otherwise, it is an indication that SLM is not communicating on the I-bus.
____________________________________
If the selector lever is moved to position M, SLM transmits a bus message. TCM is then open to up or downshifting. If the driver shifts manually, voltage is sent from pin 7 on SLM to pin 8 (A) on TCM. This is done through an analogue voltage signal sent by SLM on its own lead directly to TCM in accordance with the following:
Hold Gear voltage between 0.5 V - 1.4 V
Shift Gear -UP, (+) voltage between 1.4 V - 1.79 V
Shift Gear-DOWN (-) voltage between 2.7 V - 3.5 V

(These voltage levels can be measured when all contacts are engaged.)

Functions in the diagnostic tool related to the fault:

Test value:
Selector Position Sentronic
Selector Position Sentronic Up
Selector Position Sentronic Down
Shift Lever Sentronic