SAAB WIS ONLINE

Engine control module, removing and fitting

Engine control module, removing and fitting

To remove

Note

Before changing engine control module, see Before removing a control module .



1. Remove the engine protection cover.

2. Disconnect the ground cable from the battery.

3. Undo both cable set connectors (1) and pull them off from the engine control module.


4. Undo the knock sensor cable set connector (2) and pull out from the holder.

5. Remove the retaining bolt (6) - remove the holder (5) and the ground cable (7) from the engine control module.

6. Undo the retaining bolt (3).

7. Remove the retaining bolt (4) - remove the engine control module.


To fit


1. Fit the engine control module onto the intake manifold - tightening torque 8 Nm.

2. Fit the holder and the ground cable to the engine control module.

3. Connect the knock sensor cable set connector and fasten to the holder.

4. Fit and lock both cable set connectors to the engine control module.

5. Connect the ground cable to the battery.

6. Fit the engine cover.


Note

If the engine control module has been changed, see After changing control module .