Mass airflow sensor, removing and fitting

/ 9-3 (9440) / 2007 / 2. Engine / 1.8 XE petrol / Simtec engine management system / Adjustment/replacement / Mass airflow sensor, removing and fitting

To remove

1.	Undo the clamps.

2.	Undo the mass air flow sensor cable set connector.

3.	Remove the mass air flow sensor - note the fitting position.

To fit

1.	Put the mass air flow sensor into the intake manifold and fasten with clamps - tightening torque 3.5 Nm - note the fitting position, the arrow in the housing shows the direction flow.

2.	Connect the cable set connector.

---

---

This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.