SAAB WIS ONLINE

Particle filter/rear catalytic converter

Particle filter/rear catalytic converter

To remove


1. Remove the hoses for measuring pressure drop.


2. Remove the temperature sensor, taking care not to damage the sensor.

3. Remove the front rubber mountings.

4. Undo the rear clamp.


5. Remove the three nuts joining the particle filter/rear catalytic converter to the front pipe.


6. Remove the particle filter/rear catalytic converter rear mounting.


7. Remove the particle filter/rear catalytic converter.


To fit


1. Fit the particle filter/rear catalytic converter.


2. Fit the particle filter/rear catalytic converter rear mounting.

3. Fit the three nuts joining the particle filter/rear catalytic converter to the front pipe. Use a new gasket and new nuts.


4. Fit the rear clamp.


5. Fit the front rubber mountings.

Important

Take care when fitting so that the temperature sensor is not damaged.



6. Lubricate the temperature sensor threads with 30 20 971 Screw-thread paste . Fit the temperature sensor.

7. Fit the hoses for measuring pressure drop.

8. If a new particle filter is fitted : Connect the diagnostic tool to reset adaptation values. Select Menu - Engine - Engine management system - Adjustment - Particle Filter Replaced.