Headlamps
Headlamps |
To remove |
1. |
Open the bonnet. Remove the spoiler shield. Separate the connector and remove the contact piece. Release the washer hose where fitted.
|
2. |
Remove the bumper casing screws to the inner wing on the side where the headlamp is to be changed.
|
3. |
Remove the clip from the top radiator bracket.
|
4. |
Remove the front fixing bolts of the headlamp
|
5. |
Release one side of the bumper casing from the holder.
|
6. |
Place the casing under the casing holder. Remove the lower fixing screw for the headlamp.
|
7. |
Bend the bracket up using a chisel so that it comes away from the spacer. Lift the headlamp out.
|
8. |
Separate the connector.
|
To fit |
1. |
Plug in the connector.
|
2. |
Tip the headlamp in and guide the control stud into the hole.
|
3. |
Refit the fixing screws.
|
4. |
Raise the casing below the headlamp and guide between the headlamp and holder. Press the casing back so that the casing lugs engage in the holder.
|
5. |
Refit the bumper casing screws in the inner wing.
|
6. |
Refit the clip to the top radiator bracket.
|
7. |
Refit the spoiler shield. Plug in the connector and refit the contact piece. Refit the washer hose where applicable.
|
8. |
Check the bumper fit and headlamp setting.
|