Load angle sensor, rear
Load angle sensor, rear |
To remove |
1. |
Release the upper ball section in the link arm.
|
2. |
Remove the console and sensor.
|
3. |
Separate connector.
|
To fit |
1. |
Plug in the connector.
|
2. |
Refit console with sensor.
Tightening torque up to and including M06 8 Nm (6 lbf ft) Tightening torque from and including M07 10 Nm (7 lbf ft) |
3. |
Refit upper ball section in link arm.
|
4. |
Carry out
AHL control module calibration
.
|