Control module, TCM Z19DTH
Control module, TCM Z19DTH |
To remove |
Before removing the control module to change it, perform Before removing a control module
1. |
Remove the turbo delivery hose and glow plug relay.
|
2. |
Pull out the lock pin, press down the lock and unplug the control module connector.
|
3. |
Put the gear selector in position P and undo the nut to the lever. Engage position N before removing the lever.
|
4. |
Remove the lever. Pull back the gear cable and lift it up.
|
5. |
Remove the bolts securing the control module.
|
6. |
Lift the control module off the shaft and connector. Lift straight up to avoid damaging the connector on the gearbox.
|
To fit |
1. |
Set the inner, rotating section of the control module so that the arrow is pointing towards the marking on the housing.
|
2. |
Fit the control module. Press the control module carefully down onto the shaft and connector on the gearbox. It may be necessary to rotate the inner section of the control module slightly so that it fits the shaft. Fit the bolts.
Tightening torque: 25 Nm (18 lbf ft) |
3. |
Fit the control module connector and press in the lock pin.
|
4. |
Fit the lever and gear cable. Put the gear selector in position P.
Tightening torque 20 Nm (17 lbf ft) |
5. |
Fit the turbo delivery hose and glow plug relay.
|
6. |
Upon control module replacement:
Carry out
Procedure after control module installation
and service programming if necessary. Also carry out
Adaptation, resetting
.
|
7. |
Perform programming of the gear selector position sensor in neutral using the diagnostic tool.
|