Wiring harness valve housing with temperature sensor B284
Wiring harness valve housing with temperature sensor B284 |
To remove |
1. |
Remove the
Valve housing cover
|
2. |
Remove the
Valve housing
|
3. |
Remove the coolant pipe.
|
• |
Remove the screw (B) adjacent to the thermostat housing.
|
• |
Raise the car.
|
• |
Remove the screw (A) from the coolant pipe attaching lug.
|
• |
Lower the car to the floor.
|
• |
Remove the coolant pipe (C) and move to the side.
|
4. |
Remove the control module.
|
• |
Set the gear selector lever in position P and remove the nut (A) for the lever (B).
|
• |
Engage position N and remove the lever.
|
• |
Pull the gear cable sleeve (C) backwards and lift up the cable and move it aside.
|
• |
Remove the control module screws x 3 (D).
|
• |
Lift the control module off the shaft and connector. Lift straight up to avoid damaging the connector on the gearbox. Turn the control module away backwards.
|
5. |
Remove the wiring harness.
|
• |
Remove the circlip (A).
|
• |
Lift out the wiring harness (B).
|
To fit |
1. |
Fit the wiring harness.
|
• |
Fit a new seal (B) in the gearcase and an O-ring (A) on the connection.
|
2. |
Fit in the wiring harness (B).
|
• |
Make sure that the connector's guide pin locates in the groove and fit the circlip (A).
|
3. |
Fit the control module.
|
• |
Carefully press the control module straight and down towards the shaft and the connector.
|
• |
Fit the control module screws (D).
Tightening torque: 25 Nm (18 lbf ft) |
• |
Pull the gear cable sleeve (C) backwards and fit the cable in its bracket.
|
• |
Fit the lever (B).
|
• |
Engage position P and fit the nut (A).
Tightening torque: 15 Nm (11 lbf ft) |
• |
Engage position N.
|
4. |
Fit the coolant pipe.
|
• |
Fit a new O-ring to the thermostat housing, but do not tighten the screw before fitting the screw for the attaching lug.
|
• |
Raise the car.
|
• |
Fit the screw to the coolant pipe attaching lug (A).
|
• |
Lower the car to the floor.
|
• |
Tighten the screw on the thermostat housing (B).
|
5. |
Fit the
Valve housing
|
6. |
Fit the
Valve housing cover
|