Clutch housing
Clutch housing |
1. |
Press out the bearing race with
87 91 204 Sleeve, bearing race
, with
87 92 236 Support, for fitting F35 speed gear
for support.
|
To fit
1. |
Seat the bearing race using a plastic hammer.
|
2. |
Press the bearing to stop
83 90 312 Mandrel, bearing race, input shaft
,
83 90 114 Sleeve 4
and
87 91 311 Sleeve, driver shaft bearing
must be used.
|
Differential bearing race in clutch housing |
To remove
1. |
Carefully tap out the bearing race with a hammer and a drift (destructive removal)
|
To fit
1. |
Fit (press in) the new bearing race until they bottom with
83 90 122 Drift
and
87 91 204 Sleeve, bearing race
.
|
2. |
Fit a new seal with
87 92 657 Fitting drift, drive shaft seals
.
|