Rear subframe bush
Rear subframe bush |
Note | ||
This method involves destructive disassembly. It is not possible to refit the old bush. |
To remove |
1. |
Remove the subframe
.
|
2. |
Remove the impact buffer.
|
3. |
Cut away the rubber. Saw or cut a groove on both sides. Break off the flange from the bush to make room for the support.
|
4. |
Press out the bush using the pullrod from
89 96 779 Set of press sleeves, front assembly
and
89 96 928 Removal tool, rear subframe bushes
.
|
To fit |
1. |
Press in the bush using the pullrod from
89 96 779 Set of press sleeves, front assembly
and
89 96 910 Fitting tool, rear subframe bushes
.
Fit the bush with the rubber heels in the car's longitudinal direction. Make sure the bush is pressed in straight. |
2. |
Fit the impact buffer.
|
3. |
Fit the subframe
.
|