Heat exchanger
Heat exchanger |
To remove |
1. |
Place a container under the car and drain the coolant from the cooling system.
|
2. |
Dismantle the pipe from the heat exchanger by pulling up the clasp and pulling the pipe straight forwards.
|
3. |
Place a container under the car. Hold one of the pipes with a cloth. Blow compressed air into the other pipe so that the heat exchanger is drained of coolant.
|
4. |
Remove the
glove box
.
|
5. |
Dismantle the floor console's front side panel on the passenger side.
|
6. |
Dismantle the
passenger acoustic insulation
.
|
7. |
Dismantle the ACC module or the MCC module.
|
8. |
Remove the
ashtray
.
|
9. |
Remove the dashboard's side cover and the passenger side's A-pillar trim.
|
10. |
Dismantle the nuts holding the dashboard on the passenger side.
|
11. |
Dismantle the nuts holding the dashboard.
|
12. |
Remove the heat exchanger's cover.
|
13. |
Dismantle the pipe clamps from the heat exchanger.
|
14. |
Pull the pipes out from the heat exchanger.
|
15. |
Carefully pull out the dashboard on the passenger side. Carefully pull out the heat exchanger.
|
To fit |
1. |
Replace the O-rings. Insert the heat exchanger into position.
|
2. |
Carefully insert the dashboard into position on the passenger side.
|
3. |
Fit the pipes onto the heat exchanger and fit the pipe clamps.
|
4. |
Fit the heat exchanger's cover.
|
5. |
Fit the nuts that hold the centre of the dashboard.
|
6. |
Fit the nuts holding the dashboard on the passenger side.
|
7. |
Fit the dashboard's side cover and the passenger side's A-pillar trim.
|
8. |
Fit the
ashtray
.
|
9. |
Fit the ACC module or the MCC module.
|
10. |
Fit the
passenger acoustic insulation
.
|
11. |
Fit the floor console's front side panel on the passenger side.
|
12. |
Refit the
glove box
.
|
13. |
Fit the pipes onto the heat exchanger.
|
14. |
Fill the cooling system with coolant and
vent the cooling system
.
|