SAAB WIS ONLINE

Bonnet

Bonnet

Removing

Note

It is recommended that 2 people carry out steps 6-9.



1. Open the bonnet.

2. Loosen the left bonnet seal a little.


3. Remove the clip on the cowl cover and lift the cover a little.

4. Loosen the washer hose clip and lift up the hose.

5. Part the washer hose's quick connector. Pull of the cover to the hinges.


6. Remove the bonnet's lower bolts.

7. Loosen the upper bolts.

8. Loosen the bonnet damper's upper mounting, locked using a clip. Lay the damper down so as not to damage the paintwork.

9. Lift off the bonnet.


Fitting

Note

It is recommended that 2 people carry out steps 1, 2, and 3.



1. Lift the bonnet back into place.

2. Fit the bolts


3. Assemble the bonnet damper's upper mounting in the bonnet. Tighten the bolts.

4. Fit the hose on the hinge cover.


5. Fit the hinge covers. Make sure the clips engage properly.

6. Connect the washer hose to the quick connector. Place the washer hose under the cowl cover.

7. Fit the washer hose's clips under the cowl cover.


8. Fit the cowl cover's clips

9. Fit the rear bonnet seal.

10. Check the bonnet's alignment and the function of the bonnet lock and washers.