Front door lock unit
Front door lock unit |
To remove |
1. |
The window should be closed.
|
2. |
Remove the
Front door trim, 4D
and fold down the water barrier.
|
3. |
Cars with guard
: Remove the guard's screws.
|
4. |
Detach the lock cover to the handle rod.
|
5. |
Loosen the handle's rod from the clip.
|
6. |
Remove the bolts on the lock unit.
|
7. |
Cars with guard
: Remove the guard by coaxing it out.
|
8. |
Undo the upper rear nut to the handle.
|
9. |
Turn the lock cylinder anticlockwise and pull out the cylinder from the handle.
|
10. |
Unhook the lock cylinder from the lock rod.
|
11. |
Remove the lock from the door at an angle.
|
12. |
Part the connector.
|
To fit |
1. |
Hook the rod to the lock.
|
2. |
Run the interior handle wire along the window behind the wiring harness. Fit the clip.
|
3. |
Put the lock in place.
|
5. |
Insert the lock unit bolts.
Cars with guard : Insert the guard bolts. |
6. |
Tighten the bolts.
|
7. |
Plug in the lock connector.
|
8. |
Hook the lock cylinder to the rod.
|
9. |
Fit the lock cylinder by pushing the lock cylinder and turning it clockwise.
|
10. |
Fit the upper rear nut to the handle.
|
11. |
Fit the rod in the clip. Close the lock cover to the clip.
|
12. |
Check the function of the lock, lock cylinder and the outer handle.
|
13. |
Fit the water barrier and
Front door trim, 4D
.
|
14. |
Cars with pinch protection:
Perform
Programming of the pinch protection
.
|