SAAB WIS ONLINE

Rear seat backrest, 5D

Rear seat backrest, 5D

To remove

The 40% part of the backrest can be removed separately. The 40% part must first be removed to remove the 60% part.


1. Remove the rear seat cushion .

2. If the 60% backrest is to be removed: Remove the centre belt lower anchorage.


3. Tip forward the rear backrest.

4. Lift up the outer edge of the 40% backrest from its mounting.


Note

Take care with the side bolster. Press in the upholstery fabric while lifting up the backrest.


5. Angle the 40% backrest upwards/forwards so that it releases from the guide pin at the centre mounting and take out the backrest.


6. Lift up the outer edge of the 60% backrest from its mounting.


Note

Take care with the side bolster. Press in the upholstery fabric while lifting up the backrest.


7. Angle the 60% backrest upwards/forwards so that it releases from the guide pin at the centre mounting and take out the backrest.


To fit


1. Insert the locating pin on the 60% section into the centre mounting.


2. Fit the outer edge of the 60% backrest to its mounting and fold up the backrest.

3. Fit the belt centre anchorage and seat belt buckle.


Note

The seatbelt strap must not be twisted.

Make sure the lock guide tongue is located in the recess in the floor.


Tightening torque 45 Nm (33 lbf ft)

4. Fit the 40% section of the backrest by fitting the lower inner part of the backrest over the locating pin.


5. Fit the outer edge of the 40% section into its mounting.


6. Make sure the backrest locks securely.

7. Fit the rear seat cushion .