Seat cushion, front seat
Seat cushion, front seat |
Removing |
1. |
Turn the ignition switch to the LOCK position.
|
2. |
Raise the seat to its highest position.
|
3. |
Remove the
front seat
.
|
4. |
Place the seat on a clean surface.
|
5. |
Remove the protective cover for the side panel rear bolt and remove the bolt.
|
6. |
Place the seat so that that the bottom is easily accessible.
|
7. |
Remove the seat upholstery strips at the front and on the sides.
|
8. |
Remove the seat upholstery hooks.
|
9. |
Remove the backrest upholstery hooks.
|
10. |
Remove the connector from the seat heating pad.
|
11. |
Carefully lift up the seat cushion so that the side panel clips are accessible.
|
12. |
Remove the front R-clip from the side panel.
|
13. |
Pinch together the side panel clips with a suitable tool so that the side panel can be released.
|
14. |
Remove the side panel by first undoing it from its front mounting and then bending it back.
|
15. |
Remove the connector from the loaded seat cushion sensor.
|
Fitting |
1. |
Plug in the connector to the loaded seat cushion sensor.
|
2. |
Put in place the seat cushion.
|
3. |
Plug in the connector to the seat heating pad.
|
4. |
Fit the seat upholstery hooks.
|
5. |
Fit the backrest upholstery hooks.
|
6. |
Fit the seat upholstery strips at the front and on the sides.
|
7. |
Fit the side panel starting at the front edge.
|
8. |
Fit the side panel rear bolt and protective cover.
|
9. |
Fit the front R-clip to the side panel.
|
10. |
Fit the
front seat
.
|
11. |
Turn the ignition key to ON and make sure the airbag warning lamp goes out after 4 seconds. If the airbag warning lamp does not go out, carry out the following procedure to locate the fault.
|
12. |
Turn on the ignition and check the airbag system and control module with the diagnostic tool as follows:
Connect the diagnostic tool to the data link connector under the dashboard. Delete any fault codes. Turn off the ignition and turn it on again. Wait for at least 1 minute with the ignition on. Check if any fault codes are displayed: If a fault code is displayed:Carry out fault diagnosis as instructed for each respective diagnostic trouble code. If a fault code is not displayed:Disconnect the diagnostic tool. |