SAAB WIS ONLINE

Right engine pad, change

Right engine pad, change

Change




1. Open the bonnet

2. Remove the engine cover

Unscrew the lid on the oil filler connection

2x Unscrew

Screw on the lid on the oil filler connection

3. Remove the air cleaner casing (1)

Pull off the cable set connector (2) - mass air flow sensor

Undo the cable set (arrows)

Detach the engine ventilation hose (3)

Detach the intake hose (4)


4. Raise the car

5. Remove the wing liner.


6. Fit KM-6313 (83 96 145 Centring fixture, subframe - engine with 83 96 368 Additional kit for centring fixture )

Place KM-6313 to the left of the front axle member (arrows, picture I) Instruction: The guide bolt must fit in the hole in the front axle member

Put both right-hand holders onto the front axle member (arrows, picture II) Instruction: The guide bolt must be in the hole in the front axle member (arrow, picture III)

2x Tighten bolt


7. Fit support

On KM-6313 - Adjust the support mounting

Screw on the nut


8. 3x Adjust the support

Gearbox end Instruction: Turn the spindle until the brackets (1) are firmly against the guide pins

Engine control end Instruction: Insert the support pin firmly into the engine block hole (arrow). Tighten the bolts, nut and support

9. Lower the car

10. Remove the right-hand engine pad

Undo the engine holder adapter - 3x Unscrew bolt (1)

Undo the engine pad - 2x Unscrew bolt - Unscrew nut (2)


11. Fit the right-hand engine pad

Fasten the engine holder adapter - 3x Tighten the bolt - Tightening torque 55 Nm

Fasten the engine pad - 2x Tighten the bolt - Tightening torque 55 Nm - Tighten the nut - Tightening torque 55 Nm

12. Raise the car

13. Remove the support

Engine control side

14. Remove KM-6313

15. Fit the wing liner.

16. Lower the car

17. Fit the air filter housing

Fit the intake hose

Fit the engine vent hose

Connect cable set connector

Fasten the cable set

18. Replace the engine cover.

Unscrew the lid on the oil filler connection

2x Tighten bolt - Tightening torque 8 Nm

Screw on the lid on the oil filler connection

19. Close the bonnet