SAAB WIS ONLINE

Rear silencer

Rear silencer

To remove


1. Raise the car.

2. Cut the exhaust pipe to the specified dimension. Cut the pipe at right angles. Use 83 95 667 Pipe cutter/exhaust system .


3. Remove the rear silencer.


To fit


1. Clean the cut to remove burrs and dirt.

2. Fit a sleeve clamp to the pipe.

3. Fit the rear silencer with new rubber mountings.

4. If necessary, change also the rubber mountings suspending the front silencer.

5. Adjust the sleeve clamp so that the pipe ends are in the centre of the clamp.

6. Adjust the front and rear silencers so they hang evenly.

7. Tighten the nuts on the clamp.

Tightening torque Nm ( lbf ft).

8. Lower the car.

9. Connect an exhaust hose and start the engine. Check the exhaust system for leaks.