Engine oil level switch (243), Simtec
| Engine oil level switch (243), Simtec |
| Location |
Engine oil level switch (243)
| Principal use |
The sensor sends a message to the engine control module, which confirms that the level is low by evaluating the time it has been low.
The engine control module then transmits the bus message "Oil level low", which is used by SID. The information from the oil level sensor is a filtered value as temperature, engine speed, acceleration, and speed are used to calculate the average oil level.
It is still important that the oil level is checked using the dipstick as before as that message is not sent in SID. If the message is nonetheless displayed, the oil level is at MIN on the dipstick.
| Type |
The sensor is a float-type, i.e. when the oil level is too low in the oil pan, the float in the sensor sinks and the ground circuit to the control module is interrupted.
| Connection |
| Pin No. | Signal type | Description |
| 1 | Ground | Sensor's ground. |
| 2 | Ground | The level switch is supplied 5 V via a resistor from ECM pin 59(B). The sensor grounds the input when the oil level is low. |
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
