Exhaust system assembly, Z19DTR

/ 9-3 (9440) / 2008 / 2. Engine / 4-cylinder diesel / Exhaust system / Adjustment/replacement / Exhaust system assembly, Z19DTR

To remove

1.	Raise the car.

2.	Slacken the nut of the exhaust pipe clip.

3.	Remove the exhaust system.

To fit

1.	Fit and adjust the exhaust system so it hangs neutrally. For cars with visible tailpipe, adjust such so that it is in the centre of the tailpipe opening in the rear bumper.

2.	Tighten the exhaust pipe clip. Tightening torque 40 Nm (30 lbf ft)

3.	Lower the car.

4.	Connect exhaust hoses and start the engine. Check that the exhaust system does not leak.

---

---

This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.