Heat shield, Z19DT
Heat shield, Z19DT |
Important | ||
Always use wing covers when working in the engine bay. |
||
To remove |
|
1. |
Drain the coolant
. Then fit the spoiler shield.
|
2. |
Remove the heat shield lower nuts and bolts.
|
3. |
Lower the car.
|
4. |
Remove the upper engine cover and insulation.
|
5. |
Remove the screw holding the dipstick tube.
|
6. |
Remove the turbo delivery pipe and hoses. Plug the pipe and hoses.
|
7. |
Remove the delivery hose from the throttle body and delivery pipe.
|
8. |
Remove the upper coolant hose from the thermostat housing and bend it aside.
|
9. |
Remove the coolant pipe to the reservoir from the engine, two mountings, and the hose from the manifold. Move aside.
|
10. |
Remove the radiator fan connector.
|
11. |
Remove the top heat shield bolts and lift up the heat shield.
|
To fit |
1. |
Put in place the heat shield. Check that the front catalytic converter studs fit in the shield.
|
2. |
Fit the upper bolts.
|
3. |
Plug in the fan connector.
|
4. |
Fit the coolant pipe to the reservoir from the engine, two mountings and the hose from the manifold.
|
5. |
Fit the upper coolant hose to the thermostat housing.
|
7. |
Remove the plugs and fit the turbocharger delivery pipe and hoses.
|
8. |
Fit the screw holding the dipstick tube.
|
9. |
Fit the insulation and the upper engine cover.
|
10. |
Raise the car.
|
11. |
Fit the heat shield lower nut and bolt.
|
12. |
Fit the lower engine cover.
|
13. |
Lower the car.
|
14. |
Fill with coolant
.
|