SAAB WIS ONLINE

Rear silencer

Rear silencer

To remove


1. Raise the car.

2. Cut the exhaust pipe to the specified measurement - 130 mm on the side to be replaced. Cut the pipe perpendicularly. Use 83 95 667 Pipe cutter/exhaust system .


3. Remove the rear silencer.


To fit


1. Clean the cut to remove burrs and dirt.

2. Fit the joint clamp to the pipe. The opening should face the rear.


3. Fit the rear silencer with new rubber mountings.

4. If necessary, replace the rubber mountings of the front silencer and the other rear silencer.

5. Adjust the joint clamp so that the pipe ends are in the centre of the clamp.

6. Adjust the front and rear silencers so they hang evenly.

7. If the tale pipe is visible: Check that the tail pipe is in the centre of the recess and flush with the rear bumper.

8. Tighten the nuts on the clamp.

Tightening torque 40 Nm (30 lbf ft).

9. Lower the car.

10. Connect an exhaust hose and start the engine. Check the exhaust system for leaks.