SAAB WIS ONLINE

Master cylinder, RHD

Master cylinder, RHD

To remove


1. Apply wing covers.

2. Connect 88 19 096 Bleeding equipment hose to the bleed nipple on the slave cylinder and draw out the brake fluid from the clutch system.


3. Remove the accumulator from the master cylinder and the hose from the brake fluid reservoir.


4. Remove the centre console right-hand front side panel.


5. Remove the data link connector and the lower dashboard panel.

6. Remove both main cylinder nuts.


7. Remove the pushrod from the clutch pedal. Use a pair of pliers with bent jaws.

8. Remove the master cylinder.


To fit


1. Transfer the hose to the new master cylinder.


2. Fit the master cylinder.


3. Press on the pushrod and tighten the nuts.

Tightening torque 20 Nm (15 lbf ft)

4. Pull out the adjustment rod from the self-adjusting cruise control switch and press it back with the pedal for correct adjustment.

5. Fit the lower dashboard panel and the data link connector.


6. Fit the centre console right-hand front side panel.

7. Connect the hose from the brake fluid reservoir.


8. Fit the accumulator.

9. Bleed the clutch as described in Bleeding the clutch hydraulic system in the car .

10. Remove the wing covers.

11. Test the clutch operation.