Drive axle universal joint (gearbox side), remove and install F17
|
|
Drive axle universal joint (gearbox side), remove and install F17
|
|
2.
|
Clamp the drive shaft in a vice
Use protective vice clamps
|
|
3.
|
Remove the clips of the rubber gaiter (1)
Use a suitable tool
Note: It is not possible to remove the clips without destroying them.
|
|
4.
|
Slide the rubber gaiter (2) rearwards on the drive shaft (arrow)
|
|
5.
|
Clean the drive shaft universal joint
Clean the drive shaft universal joint thoroughly so that the circlip (1) is easily accessible.
|
|
6.
|
Remove the universal joint from the drive shaft
Undo the circlip (1) using circlip pliers (2)
Remove the universal joint from the drive shaft (arrow)
|
|
7.
|
Remove the circlip (1) from the universal joint
|
|
8.
|
Remove the rubber gaiter (2) from the drive shaft
To fit
|
|
9.
|
Fit a new circlip (1) in the joint
Note: Make sure the circlip is properly positioned.
|
|
10.
|
Slide a new rubber gaiter (2) with new clip on the drive shaft.
|
|
11.
|
Slide the universal joint on the drive shaft
Note: Slide the joint in on the drive shaft until the circlip (1) engages.
|
|
12.
|
Fill the joint and rubber gaiter with special grease
Note: Use the special grease included in the kit.
|
|
13.
|
Fit the rubber gaiter on the joint and drive shaft
Slide the rubber gaiter on the joint
Note: Make sure that the rubber gaiter is properly positioned on the drive shaft and joint.
|
