Shift cables, remove and install F17
|
Shift cables, remove and install F17
|
2.
|
Remove the air guide of the rear mixed air vent (3)
Undo the clip (4)
Remove the air guide
|
3.
|
Remove the holder (1)
Disconnect the wiring harness connector (2)
Undo 2 bolts (arrows)
Important: Only open the clamping piece to the catch (5). If it is opened farther (over extended), it could be ruined.
|
4.
|
Detach the clutch cables (2) from the gear lever unit
Detach the selector cable from the clamping piece (4)
Note: Open the clamping piece carefully with a small screwdriver
Detach the clutch cable from the clamping piece (3)
Note: Open the clamping piece carefully with a small screwdriver
|
5.
|
Remove the centre console left-hand front side panel.
|
6.
|
Remove the gaiter for the air duct.
|
7.
|
Undo the plastic cover for the gear lever and the rubber mat in the storage compartment and bend it up.
|
8.
|
Detach the cable adjusters in the gear lever housing with a screwdriver.
Important
|
Ensure that the wire adjustment is not damaged.
|
|
|
9.
|
Press the catches and detach the cable sheaths from the gear lever housing. Lift the air duct slightly with a large screwdriver when the detaching the cable sheaths.
|
10.
|
Detach the clutch cables (2) from the gearbox
2 times - prise loose from transfer arm KM-6042 (3)
2 times - release from support
Note: Pull back the sleeve (1) and pull the cable out of the support.
|
11.
|
Remove the steering gaiter (4)
Detach from bulkhead wall
|
12.
|
Remove the clutch cables
Remove forwards
To fit
|
13.
|
Insert the cable through the engine bay.
|
14.
|
Attach the cable sheaths and cables to the gear lever housing. Fit the black and white cables on the black and white adjusters respectively.
|
15.
|
Fit the plastic grommet into the bulkhead wall and the rubber seal.
|
16.
|
Raise the car and fit the cable grommet from below. The cable must be on the left-hand side of the grommet. Fit the left torque rod. Lower the car.
Tightening torque 70 Nm +90°(52 lbf ft +90°)
|
17.
|
Fit the cables to the cable retainers on the gearbox by pulling back the locking sleeves. (White to lower retainer and black to upper one)
|
18.
|
Attach the cable connections to the selector arms.
|
19.
|
Adjust gear change. See Gear cable
|
20.
|
Fit the plastic cover for the gear lever and the rubber mat in the storage compartment.
|
21.
|
Fit the gaiter for the air duct.
|
22.
|
Fit the centre console left-hand front side panel.
|
23.
|
Check the shifting positions.
|