SAAB WIS ONLINE

Anti-roll bar bush, rear

Anti-roll bar bush, rear

To remove


1. Raise the car.

2. Detach the anti-roll bar from the steering swivel members.


3. Remove the anti-roll bar mountings from the subframe.

4. Remove the bushes from the anti-roll bar.


To fit


1. Clean the anti-roll bar and grease the inside of the bushes with 30 20 476 Ball bearing grease . Fit the bushes to the anti-roll bar and fit the caps.

2. Fit the anti-roll bar to the subframe.

Tightening torque bolt 8·8 (flange diameter 15.2 mm): 18 Nm (13 lbf ft) and use Thread locking adhesive, Loctite 242

Tightening torque bolt 10·9 (flange diameter 16.7 mm): 31 nm (23 lbf ft)


3. Fit the anti-roll bar link to the steering swivel member on both sides.

Tightening torque 53 Nm (39 lbf ft)

4. Lower the car to the floor.