SAAB WIS ONLINE

Add Control module (without sec. acc.)

Add Control module (without sec. acc.)

This procedure applies to control modules that do not require security access.

The ACC is used here as an example. This means that when you add other control modules, not all questions will be similar but the function is the same.

Before proceeding, certain checks are performed.

AutoProposal is a function that makes it easier to add an ECU. When you start to "Add", Tech 2 will first examine the car's equipment. Tech 2 will then, as far as possible, pre-select the correct equipment option. You only need to confirm the suggestions. In the cases where Tech 2 cannot make a suggestion the cursor will remain on the empty top row. In which case, use the help document to make the correct selection.

Task Status
Checking Preconditions OK
Checking SPS OK
Checking Security Access Working
Adding Unit
Updating Bus Config
Clear all DTC's


Afterwards, different parameter options are presented. If an option is pre-selected, it has been identified in the car by Tech 2 and can be confirmed or changed.

Select Option
Steering Wheel Position
Left
Right


Select the desired option and confirm with Enter Key.

Select Option
Engine Fuel Type
Petrol
Diesel
Help * Back


Select the desired option and confirm with Enter Key.

Select Option
Parking Heater
Without
With
Back


Select the desired option and confirm with Enter Key.

Select Option
Market
EU
GB
ME
AU
US
1/8
Help * Back


Select the desired option and confirm with Enter Key.

Confirm Selections
Press <OK> to confirm, <BACK> to change selections.
Steering Wheel Position
Engine Fuel Type
Parking Heater
Market
Engine Fuel Type
Petrol **
Help * Back OK


* Help regarding how questions are interpreted and answered can be found here.

** Selections for each corresponding question can be viewed here.