Left engine pad, change
Left engine pad, change |
Change |
1. |
Open the bonnet
|
2. |
Disconnect the battery.
Remove the ground cable. |
3. |
Remove the battery.
Remove the guard Disconnect the positive cable (1) Remove the holder (2) - Unscrew the bolt (3) |
5. |
Raise the car
|
6. |
Fit KM-6313 (
83 96 145 Centring fixture, subframe - engine
with
83 96 368 Additional kit for centring fixture
) (1)
Place 83 96 145 Centring fixture, subframe - engine to the left of the front axle member (arrows, picture I) Instruction: The guide bolt must be in the hole in the front axle member Put both right-hand holders onto the front axle member (arrows, picture II) Instruction: The guide bolt must be in the hole in the front axle member (arrow, picture III) 2x Tighten bolt |
7. |
Fit support
On KM-6313 - Adjust the support mounting Screw on the nut |
8. |
3x Adjust the support
Gearbox end Instruction: Turn the spindle until the brackets (1) are firmly against the guide pins Engine control end, Instruction: Insert the support pin firmly into the engine block hole (arrow). Tighten the bolts, nut and support |
9. |
Lower the car
|
10. |
Remove the left engine pad
3x Unscrew (1) |
11. |
Remove the gearbox left holder
3x Undo the bolt (2) |
12. |
Remove the left engine pad
4x Undo the bolt To fit |
13. |
Fit the left engine pad
4x Tighten bolt - Tightening torque 20 Nm |
14. |
Fit the gearbox left holder
3x Tighten bolt - Tightening torque 80 Nm |
15. |
Fit the left engine pad
3x Tighten bolt - Tightening torque 55 Nm |
16. |
Fit the battery holder
3x Tighten bolt Fit the ground distributor - Tighten the bolt Fit the positive distributor - Tighten the bolt Fasten the cable set Fasten the coolant hose. |
17. |
Fit the battery.
|
18. |
Raise the car
|
19. |
Remove the support
Engine control side |
20. |
Remove KM-6313
|
21. |
Lower the car
|
22. |
Connect the battery.
|
23. |
Program erased memories
|
24. |
Close the bonnet
|