Position sensor, intake camshaft, front cylinder bank (555F)
Position sensor, intake camshaft, front cylinder bank (555F) |
To remove |
|
1. |
Drain the coolant
|
2. |
Lower the car.
|
3. |
Remove the upper engine cover.
|
4. |
Detach the turbocharger intake hose.
|
5. |
Remove the air cleaner casing cover and the air cleaner.
|
6. |
Detach the intake hose and remove the air cleaner casing.
|
7. |
Remove the coolant pipe from the port.
|
8. |
Position a jack under the oil sump and relieve the load on the engine mounting.
|
9. |
Remove the engine pad from the body and bracket.
|
10. |
Unplug the connector from the intake air sensor.
|
11. |
Detach the upper turbocharger delivery pipe from the throttle body and detach the lower delivery pipe.
|
12. |
Remove the P-clamp of the servo pipe.
|
13. |
Remove the engine bracket.
|
14. |
Detach the coolant hose from the port.
|
15. |
Remove the position sensor connector.
|
16. |
Remove the position sensor.
|
To fit |
1. |
Fit the position sensor using a new O-ring coated with a thin layer of
acid-free vaseline
.
Tightening torque 10 Nm (7.5 lbf ft) |
2. |
Plug in the connector.
|
3. |
Fit the coolant hose to the port.
|
4. |
Fit the engine bracket.
Tightening torque, M12: 93 Nm (69 lbf ft) Tightening torque, M10: 42 Nm (31 lbf ft) |
5. |
Fit the P-clamp of the servo pipe.
|
6. |
Fit the upper turbocharger delivery pipe to the throttle body and the lower delivery pipe.
|
7. |
Plug in the connector to the intake air sensor.
|
9. |
Remove the jack.
|
10. |
Fit the coolant pipe to the port using a new O-ring coated with a thin layer of
acid-free vaseline
.
|
11. |
Fit the air cleaner casing and intake hose.
|
12. |
Fit the air cleaner and the air cleaner casing cover.
|
13. |
Fit the turbocharger inlet hose.
|
14. |
Fit the upper engine cover.
|
15. |
Fill with coolant
.
|
16. |
Pressure test the cooling system
.
|