Front silencer
Front silencer |
To remove |
1. |
Raise the car.
|
2. |
Undo the nuts of the exhaust pipe clamp.
|
3. |
Cut the exhaust pipe to the specified measurement - 130 mm. Use
83 95 667 Pipe cutter/exhaust system
.
Hang up the silencer using 83 95 212 Strap . |
4. |
Remove the front silencer.
|
To fit |
1. |
Clean the joints and connecting pipe.
|
2. |
Fit the joint clamps.
|
3. |
Fit the front pipe with new rubber mountings.
|
4. |
If necessary, replace the rubber mountings of the rear silencers.
|
5. |
Adjust the joint clamps so that the pipe joints are centred in them. The opening should face the rear.
|
6. |
Adjust the front and rear silencers so they hang evenly.
|
7. |
For cars with visible tailpipe, adjust this so that it hangs in the centre of the tailpipe cutout in the rear bumper.
|
8. |
Tighten the joint clamp nuts.
Tightening torque 40 Nm (30 lbf ft) |
9. |
Tighten the front exhaust pipe clip.
Tightening torque 40 Nm (30 lbf ft) |
10. |
Lower the car.
|
11. |
Attach the exhaust hoses and start the engine. Check that there are no exhaust system leaks.
|