SAAB WIS ONLINE

Headlamps, programming

Headlamps, programming

Programming, headlamps

The vehicle can be programmed for three different types of headlamp logic:

Important

Switching between main and dipped beams is only possible with the light switch in position 2. Applies to all alternatives.

Fuse 35 has been removed from cars on markets where daytime running lights are not used. Program alternatives 1 and 2.

While the engine is being started, dipped beam is turned off. This is irrespective of the program alternative if the light switch is in position 0 or 1, but for safety reasons it is maximized to 20 seconds.


Alternative 1

When the light switch (10) is in position 0 or 1, none of the main lighting should be active.

In position 0, none of the parking lights should be active. (Germany + other markets).

Alternative 2

When the light switch is in position 0, dipped beams should be on (daytime running lights).

In position 0 it is not possible to switch between main and dipped beams (Sweden).

Alternative 3

When the light switch is in position 0 or 1, the dipped beams should be on.

In position 0 or 1 it is not possible to switch between main and dipped beams (Canada).

Programming, parking lights

Acoustic warning (yes/no)

Pre-programmed: yes