Light setting, fog lights (US/CA)
|
Light setting, fog lights (US/CA)
|
1.
|
Check that all tyres have the correct air pressure.
|
2.
|
Check that there is no load in the car.
|
3.
|
Check fuel quantity. Compensate with load in the luggage compartment:
half tank - 25 kg; empty tank - 50 kg
|
4.
|
One person or a 75 kg load should be in the driver's seat.
|
5.
|
The car should be free from snow and ice.
|
6.
|
Park the car on a flat surface.
|
7.
|
Stabilise the suspension by rocking the car.
|
8.
|
Check the mounting of the bulb in the headlamp.
|
9.
|
Switch on the ignition.
|
Light setting against a wall
|
1.
|
Park the car 25 ft (7.6 m) from the wall (A).
|
2.
|
Measure from the ground to the centre of the fog light lens (B), subtract 4 inches (10 cm) and note the measurement.
|
3.
|
Measure B - 4 inches (10 cm) and draw a horizontal line on the wall the same width as the car.
|
4.
|
Switch on the fog lights.
|
5.
|
Screen off the fog light not being set.
|
6.
|
Use the adjuster screw (C) to adjust the light image vertically until the image's baseline matches the horizontal line on the wall.
|
7.
|
Perform points 5 and 6 for the other front fog light.
|
Light setting with special equipment
|
1.
|
For handling of light setting equipment, see the user's manual from the manufacturer.
|
2.
|
Adjust the light image vertically using the adjuster screw (C).
|