Load angle sensor, front

/ 9-3 (9440) / 2009 / 3. Electrical System / Lighting and signalling systems / Headlight adjustment / Adjustment/replacement / Load angle sensor, front

To remove

1.	Release the upper ball section in the link arm.

2.	Remove the console and sensor.

3.	Separate connector.

To fit

1.	Plug in the connector.

2.	Refit console with sensor.

3.	Refit upper ball section in link arm.

4.	Carry out AHL control module calibration .

---

---

This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.