Starter motor, Z19DTR
Starter motor, Z19DTR |
To remove |
1. |
Remove the battery cover.
|
2. |
Disconnect the negative battery cable.
|
3. |
Remove the upper engine cover and the sound insulation.
|
4. |
Remove the starter motor's upper bolts (A) and the bracket (B).
|
5. |
Raise the car.
|
6. |
CV:
Remove
chassis reinforcement, front subframe
.
|
7. |
Remove the lower engine cover (A).
|
8. |
Detach the starter motor connecting cables (A).
|
9. |
Detach the ground cable (B) from the lower stud on the starter motor.
|
10. |
Remove the lower stud from the starter motor (C).
|
11. |
Lower the starter motor and lift it out.
|
To fit |
1. |
Lift the starter motor into place and thread the lower stud.
|
2. |
Lower the car.
|
3. |
Fit the bracket (B) and the starter motor's upper bolts (A).
Tightening torque 24 Nm (18 lbf ft) |
4. |
Raise the car.
|
5. |
Tighten the lower stud (C).
Tightening torque 24 Nm (18 lbf ft) |
6. |
Attach the starter motor connecting cables (A).
|
7. |
Attach the ground cable to the lower stud (B).
|
8. |
Fit the lower engine cover (A).
|
9. |
CV:
Fit
chassis reinforcement, front subframe
.
|
10. |
Lower the car.
|
11. |
Fit the negative battery cable.
|
12. |
Fit the battery cover.
|
13. |
Carry out
Procedures after disconnecting the battery
.
|