Intermediate shaft, B284
Intermediate shaft, B284 |
To remove |
1. |
Raise the car and remove the front right wheel.
CV:
Remove the chassis reinforcement.
|
2. |
Man, aut:
Drain the gearbox oil.
|
3. |
Undo the outer ball joint from the suspension arm. Remove the clip holding the brake hose.
|
4. |
Lower the suspension arm and place a
83 95 238 Wedge
between the anti-roll bar and arm.
|
5. |
Tap out the inner drive shaft joint with a mallet and brass drift.
|
6. |
Remove the bolts and withdraw the intermediate shaft.
|
7. |
Change shaft seal in the gearbox, see
Drive shaft seal, right-hand
.
|
To fit |
1. |
Place a
83 95 162 Protective collar, drive shafts
in the shaft seal. Insert the intermediate shaft into the gearbox until about 20 mm is left. Pull out the collar and push in the rest of the intermediate shaft.
|
2. |
Fit and tighten the bolts.
Tightening torque 10 Nm (7 lbf ft) |
3. |
Lubricate the drive shaft splines with
90 513 210 Universal paste
and make sure the rubber seal is on the shaft.
|
5. |
Remove the wedge and attach the ball joint to the steering swivel member with a bolt and nut. The pin must be visible above the steering swivel member before the bolt is fitted. Tighten the nut.
Tightening torque 50 Nm (37 lbf ft) |
6. |
Fit the clip to the brake hose.
|
7. |
Fill the gearbox with oil.
Man:
see
Topping up/changing gearbox oil B284
.
Aut:
see
Changing transmission fluid B284
.
|
8. |
Fit the wheel. See
Wheels
.
|
9. |
CV:
Fit the chassis reinforcement.
|
10. |
Lower the car to the floor.
|