Intermediate shaft, Z19
Intermediate shaft, Z19 |
To remove |
1. |
Raise the car and remove the front right wheel.
|
2. |
Remove the lower engine cover.
|
3. |
Drain the gearbox oil.
|
4. |
Detach the outer ball joint from the suspension arm.
|
5. |
Lower the suspension arm and place a
83 95 238 Wedge
between the anti-roll bar and arm.
|
6. |
Tap out the inner drive shaft joint with a mallet and brass drift.
|
7. |
Remove the bolts and withdraw the intermediate shaft.
|
8. |
Change shaft seal in the gearbox, see
Drive shaft seal, right-hand
.
|
To fit |
1. |
Place a
83 95 162 Protective collar, drive shafts
in the shaft seal. Insert the intermediate shaft into the gearbox until about 20 mm is left. Pull out the collar and push in the rest of the intermediate shaft.
|
2. |
Fit and tighten the bolts.
Tightening torque 20 Nm (15 lbf ft) |
3. |
Lubricate the drive shaft splines with
90 513 210 Universal paste
and make sure the rubber seal is on the shaft.
|
5. |
Fill the gearbox with transmission fluid. See Filling transmission fluid.
|
6. |
Fit the lower engine cover.
|
7. |
Fit the wheel. See
Wheels
.
|
8. |
Lower the car to the floor.
|