Help with fault analysis in the event of claims concerning noise from a manual gearbox
|
Help with fault analysis in the event of claims concerning noise from a manual gearbox
|
Transmission noise may not always come from the manual gearbox. The following table should be used to reduce noise relating to the F 17 manual gearbox.
1. The car is stationary and the engine is idling
The noise only arises when the clutch pedal is depressed:
|
Type of noise
|
Extra information
|
Action
|
Bearing noise
|
Vibrating clutch pedal
|
Check the clutch plate.
Check the position of the clutch delivery line.
|
Knocking noise
|
Audible sound, usually at lower engine speeds.
|
Further fault diagnosis on the engine
|
The noise arises irrespective of clutch pedal position:
|
Type of noise
|
Extra information
|
Action
|
-
|
Vibrating clutch pedal
|
Localise the noise source on the engine
|
The noise increases when the clutch pedal is depressed:
|
Type of noise
|
Extra information
|
Action
|
-
|
The noise comes from the engine
|
Check the central clutch release bearing
|
Rattling
|
With gear engaged
|
Check the synchromesh of the gear
|
2. The car is being driven
The noise occurs only with depressed clutch pedal:
|
Type of noise
|
Extra information
|
Action
|
Howling, whining
The noise depends on the loading condition in all gears:
|
The noise increases with the 1st, 2nd, 3rd, 4th or reverse gears engaged and with higher speed
|
Change the pinion of the respective gear and the gear wheel block
|
The noise increases predominantly in 4th gear and is audible in all the other gears
|
Check the differential gears, replace if necessary
|
Rattling
|
Audible with change from 2-1
|
Check the synchromesh of the 5th gear
|
Audible with acceleration from low engine speed and in each gear engaged
|
Check the tooth flank clearance on the wheel pair for the gear in question and replace if necessary
|
Scraping/slipping sound
|
When stationary and without depressed clutch pedal, gears not synchronous
|
|
The sound reduces when the gears are asynchronised
|
|
Check the synchromesh on every asynchronised gear
|
The sound increases when the gears are asynchronised
|
Check the selector forks on each asynchronised gear and the track in the synchromesh hub or sleeve
|
Replace the pertinent selector fork/ synchromesh sleeve or hub
|
Sound unchanged
|
Check the play between the clutch gears and the baulk rings
Check the tooth flank backlash between the gear wheel block and the pinion
|
Change the complete bearing housing
|
The source of the noise cannot be detected using the fault diagnosis described above: Investigate and locate the noise at shaft bearings, wheel bearings and drive shafts
|