Add Control module (without sec. acc.)
Add Control module (without sec. acc.) |
This procedure applies to control modules that do not require security access.
The ACC is used here as an example. This means that when you add other control modules, not all questions will be similar but the function is the same.
Before proceeding, certain checks are performed.
AutoProposal is a function that makes it easier to add an ECU. When you start to "Add", Tech 2 will first examine the car's equipment. Tech 2 will then, as far as possible, pre-select the correct equipment option. You only need to confirm the suggestions. In the cases where Tech 2 cannot make a suggestion the cursor will remain on the empty top row. In which case, use the help document to make the correct selection.
Task | Status |
Checking Preconditions | OK |
Checking SPS | OK |
Checking Security Access | Working |
Adding Unit | |
Updating Bus Config | |
Clear all DTC's |
Afterwards, different parameter options are presented. If an option is pre-selected, it has been identified in the car by Tech 2 and can be confirmed or changed.
Select Option | |||
Steering Wheel Position | |||
Left | |||
Right |
Select the desired option and confirm with Enter Key.
Select Option | |||
Engine Fuel Type | |||
Petrol | |||
Diesel | |||
Help * | Back |
Select the desired option and confirm with Enter Key.
Select Option | |||
Parking Heater | |||
Without | |||
With | |||
Back |
Select the desired option and confirm with Enter Key.
Select Option | |||
Market | |||
EU | |||
GB | |||
ME | |||
AU | |||
US | |||
1/8 | |||
Help * | Back |
Select the desired option and confirm with Enter Key.
Confirm Selections | |||
Press <OK> to confirm, <BACK> to change selections. | |||
Steering Wheel Position | |||
Engine Fuel Type | |||
Parking Heater | |||
Market | |||
Engine Fuel Type | |||
Petrol ** | |||
Help * | Back | OK |
* Help regarding how questions are interpreted and answered can be found here.
** Selections for each corresponding question can be viewed here.