Light cluster, boot lid

/ 9-3 (9440) / 2010 / 3. Electrical System / Lighting and signalling systems / Exterior lighting / Adjustment/replacement / Light cluster, boot lid

To remove

1.	Open the tailgate.

2.	Remove the inner handle. Remove the trim clips.

3.	US/CA: Detach the emergency handle from the trim. Detach the wire from the emergency handle.

4.	Slightly bend aside the trim from the cover on the lock.

5.	Loosen the trim guide clips and lift away the trim from the boot lid.

6.	Remove the lamp housing nuts.

7.	Separate the connector.

8.	Remove the lamp housing.

To fit

1.	Check the lamp housing gasket. Fit the lamp housing with nuts.

2.	Plug in the connector.

3.	Lift up the trim. US/CA: Insert the emergency handle through the trim.

4.	Position the trim at the lock cover and insert the guide clips. Press the guide clips into place.

5.	Fit the clips and the inner handle.

6.	US/CA: Attach the emergency handle to the wire. Fit the handle to the trim. Check the function of the emergency handle.

7.	Close the boot lid.

---

---

This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.