SAAB WIS ONLINE

Starter motor, Z19DTR

Starter motor, Z19DTR

To remove


1. Remove the battery cover.

2. Disconnect the negative battery cable.

3. Remove the upper engine cover and the sound insulation.

4. Remove the starter motor's upper bolts (A) and the bracket (B).


5. Raise the car.

6. CV: Remove chassis reinforcement, front subframe .

7. Remove the lower engine cover (A).


8. Detach the starter motor connecting cables (A).


9. Detach the ground cable (B) from the lower stud on the starter motor.

10. Remove the lower stud from the starter motor (C).

11. Lower the starter motor and lift it out.


To fit


1. Lift the starter motor into place and thread the lower stud.

2. Lower the car.

3. Fit the bracket (B) and the starter motor's upper bolts (A).

Tightening torque 24 Nm (18 lbf ft)


4. Raise the car.

5. Tighten the lower stud (C).

Tightening torque 24 Nm (18 lbf ft)


6. Attach the starter motor connecting cables (A).

7. Attach the ground cable to the lower stud (B).

8. Fit the lower engine cover (A).


9. CV: Fit chassis reinforcement, front subframe .

10. Lower the car.

11. Fit the negative battery cable.

12. Fit the battery cover.

13. Carry out Procedures after disconnecting the battery .