Fitting kit, anti-theft alarm, 4D, 5D
Fitting kit, anti-theft alarm, 4D, 5D |
1. |
Siren
|
2. |
Siren console
|
3. |
Bonnet switch
|
4. |
Anti-theft alarm sensor
|
5. |
Labels
|
6. |
Self-adhesive foam plug, diam. 50 mm.
|
Siren |
1. |
Open the tailgate.
|
2. |
4D:
Open the right side hatch in the luggage compartment and remove
Sound insulation, luggage compartment right.
5D: Remove right Rear side trim, 5D and Sound insulation, luggage compartment right . |
3. |
Remove the foam plug.
|
4. |
Remove the cable ties holding the cables.
|
5. |
Insert the cables through the hole.
|
6. |
Plug in the connector to the siren.
|
7. |
Fit the siren.
|
8. |
Tighten the 2 bolts securing the siren.
Tightening torque 4.0 +/- 1.2 Nm |
9. |
Fit the foam plug.
|
10. |
4D:
Install
Sound insulation, luggage compartment right
and close the side hatch.
5D: Install Sound insulation, luggage compartment right and right Rear side trim, 5D . |
11. |
Close the boot lid.
|
Bonnet switch |
1. |
Open the bonnet.
|
2. |
Remove the clip holding the cables.
|
3. |
Plug in the connector to the bonnet switch.
|
4. |
Fit the bonnet switch.
|
5. |
Close the bonnet.
|
Anti-theft alarm sensor |
1. |
Remove the lens cover from the roof lamp.
|
2. |
Remove the switch panel.
|
3. |
Remove the connector from its mounting.
|
4. |
Connect the connector to the anti-theft alarm sensor.
|
5. |
Fit the anti-theft alarm sensor. A click should be heard.
|
6. |
Remove the two protective cases from inside the switch panel.
|
7. |
Fit the switch panel.
|
8. |
Fit the lens protector.
|
9. |
Connect the diagnostic tool.
|
10. |
Select
Add / Remove- Accessories -
Theft Alarm and then follow the on-screen instructions.
|
Anti-theft alarm labels |
Affixing anti-theft alarm labels