Selector unit B284
Selector unit B284 |
To remove |
1. |
Remove the battery
|
2. |
Remove
Battery cover, lower section, B284
.
|
3. |
Remove the catalytic converter heat shields:
|
• |
Turn up the expansion tank
|
• |
Remove the heat shields (A).
|
4. |
Unplug the connector from the reversing light switch (A)
|
5. |
Remove the gearbox's bleed hose (B).
|
6. |
Remove the gear cables:
|
• |
Remove the gear cables from the shift arms (C).
|
• |
Press the locking sleeves backward and remove the gear cable sheaths from the bracket (D).
|
7. |
Blow clean around the selector unit
|
8. |
Remove the selector unit:
|
• |
The selector unit must be in neutral position to enable removal.
|
• |
Remove the bolts and lift up the selector unit (A)
|
To fit |
1. |
Fit the sealing ring onto the selector unit (A)
|
• |
The selector unit must be in neutral position to enable fitting.
|
2. |
Fit the selector unit onto the gearbox (A).
Tightening torque: 25 Nm (18 lbf ft) |
3. |
Connect the gear cables:
|
• |
Press the locking sleeves backward and fit the gear cable sheaths in the bracket (D)
|
• |
Fit the gear cables for the shift arms (C).
|
4. |
Fit the bleed hose (B).
|
5. |
Plug in the reversing light switch connector (A).
|
6. |
Fit the catalytic converter heat shields:
|
• |
Fit the heat shields (A).
|
• |
Fit the expansion tank
|
7. |
Adjust the gear positions in accordance with
Adjusting gear cables
|
8. |
Fit
Battery cover, lower section, B284
|
9. |
Fit the battery
|
10. |
Carry out
Measures after disconnecting the battery
.
|